Osburn OB01601 Instrukcja Użytkownika

READ AND KEEP THIS MANUAL FOR REFERENCE 45084A Printed in Canada 12-06-2015 OWNER’S MANUAL 1600 INSERT (OB01601 model) US ENVIRONMENTAL PRO

10MINIMUM MASONRY OPENING, CLEARANCES TO COMBUSTIBLES, AND FLOOR PROTECTOR

11 MINIMUM MASONRY OPENING MAXIMUM STANDARD FACEPLATE MAXIMUM LARGE FACEPLATE F 22.125" (562 mm) 29" (737 mm) 32" (813 mm) G 2

12VENTING REQUIREMENTS The flue is a critical component to a satisfactory installation. Your insert will attain its best performanc

13INSTALLATION INSTRUCTIONS 1. Inspect the fireplace according to the safety information and fireplace requirements and have it cleaned and/or upgra

144. POSITIONING THE UNIT: The more extended the insert, the greater the heat transfer to the room. When installed as an extended inse

155. If lag-bolts and anchors are to be used to secure the insert, the hole locations should be marked with the unit in place. Remove

167. INSTALLATION ON FACEPLATE: Attach the mitred corners of trim together using the corner brackets. Slide the assembled trim over the edge of th

1710. Push the air control (A) in, all the way. Slide the adjustable faceplate sleeve back into its original location until the faceplate fi

18OPERATION Your heating unit was designed to burn wood only; no other materials should be burnt. Wastes and other flammable materials should n

19Smaller pieces of wood will dry faster. All logs exceeding 6" in diameter should be split. The wood should not be stored directly on the gro

2 TABLE OF CONTENTS TECHNICAL SPECIFICATIONS ... 4 INSTALLA

20HEATING Controlled combustion is the most efficient technique for wood heating because it enables you to select the type of combustion you want for

21CREOSOTE FORMATION AND NEED FOR REMOVAL When wood is burned slowly, it produces tar and other organic vapours, which combine with expelled moistur

22MAINTENANCE Your OSBURN insert is a high efficiency insert and therefore require little maintenance. It is important to perform a visual inspection

23BAFFLE INSTALLATION All firebrick and ceramic wool baffles must be properly in place for correct burning operation. Have any dama

24SECONDARY AIR TUBE REPLACEMENT 1. Remove cotter pin at left end of tube. 2. Slide tube to right and lower tube end below left plenum. 3. Slid

25 OSBURN LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original retail purchaser and is not transferable. This w

3 INTRODUCTION SBI INC., one of the most important wood stove and fireplace manufacturers in Canada, congratulates you on your purchase and wi

4 TECHNICAL SPECIFICATIONS Combustible: Wood Recommended surface: Up to 1800 square feet Heating Capacity* : E.P.A :

5 INSTALLATION SAFETY NOTICE • IF THIS INSERT IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLAT

6 DOOR OVERLAY INSTALLATION In order to complete the assembly of your Osburn 1600 wood insert, you need to install the door overlay. See figure 1 be

7 DOOR ADJUSTMENT In order for your insert to operate properly, the door should be adjusted periodically to provide an air tight fit.

8 PRE-INSTALLATION REQUIREMENTS MASONRY & ZERO CLEARANCE REQUIREMENTS The masonry fireplace must meet the minimum code requirements, or NFPA 21

9 4. CHIMNEY CAPS: Mesh type chimney caps must have provision for regular cleaning, or the mesh should be removed to eliminate the potential of plu